QTL1069 - SBB Canister Control Module
Product Description
This interposer module is fitted between the SBB canister and the backplane and allows precise switching of the power and low speed signals to the canister. The high speed lines are routed directly through allowing the canister to operate normally.
The canister can be electronically hot-swapped. Each line is connected at a set time (with pin bounce if necessary) allowing any possible hot-swap scenario to be tested.
Lines can also be manually mated and broken to simulate specific failures. This is ideal for creating bugged hardware and testing dual redundant components.
Canister Control Modules can be used for simple bench testing with an interface card or as part of the Torridon system for larger scale system test.
Product Pictures
SBB Canister Control Module - Top View
Main Features
- Test the effect of single/multi point failures
- Diagnose and prevent hot-swap failures
- Automate any test requiring plug/pull of canisters
- Greatly improve test coverage while decreasing duration
- Remove human error and variability during testing
- Fully programmable and updatable
Technical Specification
- Control via Torridon Array Controller or Interface Card
- Ultra-thin ribbon cable for easy routing
- Displaces the SBB canister by approx. 80mm
- Compatible with SBB 1.0 and 2.0 canisters
Documentation
To download a document please follow the link and enter your name and email address.
Related Products
Sales and Ordering
Contact sales@quarch.com or call +44 (0)1343 508 140.